syslog-ng Open Source Edition 3.16 - Release Notes

Change an old destination driver to the network() driver

To replace your existing tcp(), tcp6(), udp(), udp6() destinations with a network() destination, complete the following steps.

1. Replace the driver with network. For example, replace udp( with network(

2. Set the transport protocol.

   • If you used TLS-encryption, add the transport("tls") option, then continue with the next step.

   • If you used the tcp or tcp6 driver, add the transport("tcp") option.

   • If you used the udp or udp driver, add the transport("udp") option.

3. If you use IPv6 (that is, the udp6 or tcp6 driver), add the ip-protocol(6) option.

4. If you did not specify the port used in the old driver, check network() destination options and verify that your clients send the messages to the default port of the transport protocol you use. Otherwise, set the appropriate port number in your source using the port() option.

5. All other options are identical. Test your configuration with the syslog-ng --syntax-only command.

   The following configuration shows a simple tcp destination.

   destination d_old_tcp {
       tcp(
           "127.0.0.1" port(1999)
           tls(
               peer-verify("required-trusted")
               key-file("/opt/syslog-ng/etc/syslog-ng/syslog-ng.key")
               cert-file('/opt/syslog-ng/etc/syslog-ng/syslog-ng.crt')
           )
       );
   };

   When replaced with the network() driver, it looks like this.

   destination d_new_network_tcp {
       network(
           "127.0.0.1"
           port(1999)
           transport("tls")
           tls(
               peer-verify("required-trusted")
               key-file("/opt/syslog-ng/etc/syslog-ng/syslog-ng.key")
               cert-file('/opt/syslog-ng/etc/syslog-ng/syslog-ng.crt')
           )
       );
   };